›› 2013, Vol. 34 ›› Issue (2): 1-1.

• 论文 •    

考虑黏弹性效应的聚合物驱流度设计方法

姜瑞忠,王公昌,姚 征   

  1. (中国石油大学 石油工程学院,山东 青岛 266580)
  • 出版日期:2019-01-01 发布日期:1905-07-10

Mobility Designing for Polymer Flooding Considering the Viscoelasticity Effect

JIANG Ruizhong, WANG Gongchang, YAO Zheng   

  1. (School of Petroleum Engineering, China University of Petroleum, Qingdao, Shandong 266580, China)
  • Online:2019-01-01 Published:1905-07-10

摘要: 聚合物溶液在渗流过程中存在黏弹性效应,此效应对于聚合物溶液的黏度有显著的影响,因此在聚合物驱流度设计中必须考虑这一因素。研究表明,当考虑聚合物溶液的黏弹性时,随着剪切速率的增加,流度设计时所需最小聚合物溶液质量浓度先增加后减小,曲线出现临界“拐点”,这与不考虑溶液黏弹性有明显的区别;且随着松弛时间的增大,在相同剪切速率下,所需最小聚合物溶液质量浓度变小,曲线整体下移,且松弛时间越大,曲线出现“拐点”的时机越早,表明黏弹性效应的增大可以降低对聚合物溶液质量浓度的要求。

Abstract: The viscoelasticity effect of polymer solution in the seepage process has a great influence on its apparent viscosity, which is why we should consider the viscoelasticity effect in the mobility designing for polymer flooding. Depending on the idea of mobility control and the concept of effective viscosity, this paper analyses the influence of the viscoelasticity effect on the minimum polymer solution mass concentration. The results shows that when the viscoelasticity effect is considered, there will be a critical point in the curve of the minimum of the polymer solution mass concentration with the increasing of shear rate, which obviously differs from the situation where the viscoelasticity effect is not considered. Meanwhile, with the increasing of the relaxation time and at the same shear rate, the minimum mass concentration as required is decreasing, the whole curve moves down, and the longer the relaxation time, the earlier the time when the critical point appears, which means the enhancing of the elasticity effect can reduce the requirements of mobility designing on the polymer solution mass concentration

中图分类号: