水平井水平段长度优化原则

摘要/Abstract

摘要： 目前,水平井水平段长度的优化大多采用Dikken 提出的优化原则,即水平段最优长度是当摩擦损失减少了20%产能时的长度。在建立水平井水平段长度优化数学模型的基础上,给出一定油藏、流体条件下水平井极限产量的计算公式;结合油藏实例,分析了Dikken 优化原则的合理性,认为以该原则计算的水平段长度不能充分发挥水平井开发油藏的潜力,相对于极限产量而言,采出程度较低;得出了以极限产量为优化标准时水平段长度的计算方法;分析了两种优化原则之间的关系。该研究对水平井开发优化设计具有指导意义。

关键词: 水平井, 长度, 优化设计, 极限产量

Abstract: At present, the optimization of horizontal wellbore length is based on Dikken's principle in most cases, that is, the optimal horizontal wellbore length is the length that the production decreases by 20% due to the friction loss. A formula is derived from the mathematic model of optimal horizontal wellbore length to calculate the ultimate output for horizontal well in definite reservoir and fluid condition. Integrated with case analysis, the rationality of Dikken's principle is analyzed. It is suggested that the horizontal wellbore length calculated by Dikken's principle cannot reach its full potential in reservoir development, and with the contrast to the ultimate output, the recovery percent is relatively low. This paper proposes the calculation method for optimal horizontal wellbore length on the basis of the ultimate output principle and analyzes the relationship between such two optimization principles. The study is of significance for guiding horizontal well development and optimization design.

Key words: horizontal well, length, optimization design, ultimate production

中图分类号:

TE243

王大为, 李晓平. 水平井水平段长度优化原则[J]. 新疆石油地质, 2011, 32(2): 163-166.

WANG Da-wei, LI Xiao-ping. Optimization Principles for Horizontal Wellbore Length[J]. Xinjiang Petroleum Geology, 2011, 32(2): 163-166.

参考文献

[1] Dikken B J.Pressure drop in horizontal wells and its effects on their production performance[A]. SPE 19824, 1990.
[2] Novy R A.Pressure drops in horizontal wells : when can they be ignored?[A]. SPE 24941, 1992.
[3] 于乐香,周生田,张琪. 水平井筒流体变质量流动压力梯度模型[J]. 石油大学学报(自然科学版),2001,25(4):47-48.
[4] 李晓平,张烈辉,李允,等. 水平井井筒内压力产量变化规律研究[J]. 水动力学研究与进展(A 辑),2005,20(4):492-496.
[5] 高海红,曲占庆,赵梅. 压裂水平井产能影响因素的研究[J]. 西南石油大学学报(自然科学版),2008,30(4):73-76.
[6] 王小秋,汪志明,魏建光. 井筒与油藏耦合条件下水平井变质量流动规律研究[J]. 水动力学研究与进展(A 辑),2005,20(3):326-331.
[7] 周生田,郭希秀. 水平井变质量流动与油藏渗流的耦合研究[J]. 石油钻探技术,2009,37(2):85-88.
[8] 范子菲,方宏长,俞国凡. 水平井水平段最优长度设计方法研究[J]. 石油学报,1997,18(1):55-62.
[9] 范子菲,李云娟,纪淑红. 气藏水平井长度优化设计方法[J]. 大庆石油地质与开发,2000,19(6):28-30.
[10] 陈海龙,李晓平,李其正. 水平井段最优长度的确定方法研究[J]. 西南石油学院学报,2003,25(1):47-48.
[11] 梁冠民,周生田. 水平井筒摩擦压降对井产能的影响[J]. 断块油气田,2007,14(5):53-55.
[12] 符奇,张烈辉,胡书勇,等. 底水油藏水平井水平段合理位置及长度的确定[J]. 石油钻采工艺,2009,31(1):51-55.
[13] 范子菲. 底水驱油藏水平井产能公式研究[J]. 石油勘探与开发,1993,20(1):71-75.
[14] 周生田,张琪. 水平井水平段压降的一个分析模型[J]. 石油勘探与开发,1997,24(3):49-52.
[15] Knut Seines, Ivak Aavatsmark, Lien S C.Considering wellbore friction in planning horizontal wells[A]. SPE 21124, 1993.